Stowage and feat ures, Features – Mercedes-Benz E-Cab 2014 Owners Manual User Manual

Page 310

Advertising
background image

The integrated garage door opener is

compatible with devices that have units

which operate in the frequency range of

280to 433MHz.

R

Replace the batteries in garage door

remote control A. This increases the

likelihood that garage door remote control

A will transmit a strong and precise signal

to the integrated garage door opener in the

rear-view mirror.

R

When programming, hold remote control

A at varying distances and angles from the

button that you are programming. Try

various angles at a distance between 2and

12 inches (5to 30 cm) or at the same angle

but at varying distances.

R

If another remote control for the same

garage door drive is available, repeat the

same programming steps with this remote

control. Before performing these steps,

make sure that new batteries have been

installed in garage door drive remote

control A.

R

Note that some remote controls only

transmit for a limited amount of time (the

indicator lamp on the remote control goes

out). Press button B on remote control

A again before transmission ends.

R

Align the antenna cable of the garage door

opener unit. This can improve signal

reception/transmission.

Opening/closing the garage door

After it has been programmed, the integrated

garage door opener performs the function of

the garage door system remote control.

Please also read the operating instructions

for the garage door system.

X

Turn the SmartKey to position 2 in the

ignition lock.

X

Press button ;, = or ? which you have

programmed to operate the garage door.

Garage door system with a fixed code:

indicator lamp : lights up green.

Garage door system with a rolling code:

indicator lamp : flashes green.

i

The transmitter will transmit a signal as

long as the button is pressed. The

transmission is halted after a maximum of

ten seconds and indicator lamp : lights

up yellow. Press button ;, = or ? again

if necessary.

Clearing the memory

X

Turn the SmartKey to position 2 in the

ignition lock.

X

Press buttons ; and ?.

The indicator lamp lights up yellow.

X

Press and hold buttons ; and ? until the

indicator lamp turns green.

i

Make sure that you clear the memory of

the integrated garage door opener before

selling the vehicle.

Floormats

G

WARNING

Objects in the driver's footwell can restrict the

pedal travel or obstruct a depressed pedal.

The operating and road safety of the vehicle

is jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are

stowed correctly, and that they cannot enter

the driver's footwell. Install the floormats

securely and as specified in order to ensure

sufficient clearance for the pedals. Do not use

loose floormats and do not place floormats on

top of one another.

308

Features

Stowage

and

feat

ures

Advertising
This manual is related to the following products: