Maintenance and care, Care – Mercedes-Benz E-Cab 2014 Owners Manual User Manual
Page 326

X
Select
Open Camera Cover
and press W
to confirm.
The cover of the 360° camera opens.
X
To clean the rear view camera: use clear
water and a soft cloth to clean camera
lens :.
Cleaning the 360° camera
!
Do not clean the camera lens and the area
around the 360° camera with a power
washer.360
X
Make sure that the vehicle is stationary and
that the SmartKey is in position 2 in the
ignition lock.
X
To open the cover of the 360° camera:
with COMAND activated, press the W
button.
X
Select
Syst. settings
by turning cVd
the COMAND controller and press W to
confirm.
X
Select
360° Camera
and press W to
confirm.
X
Select
Open Camera Cover
and press W
to confirm.
The cover of the 360° camera opens.
X
To clean the 360° camera: clean camera
lens : with clean water and a soft cloth.
i
If you drive at speeds above 20 mph
(30 km/h) or the SmartKey is in position
0 or 1 in the ignition lock, the cover of the
360° camera closes automatically.
Cleaning the exhaust pipes
!
Do not clean the exhaust pipe with acid-
based cleaning agents such as sanitary
cleansers or wheel cleaners.
Impurities combined with the effects of road
grit and corrosive environmental factors may
cause flash rust to form on the surface. You
can restore the original shine of the exhaust
pipe by cleaning it regularly, especially in
winter and after washing.
X
Clean the exhaust pipe with a care product
tested and approved by Mercedes-Benz.
Interior care
Cleaning the display
!
For cleaning, do not use any of the
following:
R
alcohol-based thinner or gasoline
R
abrasive cleaning agents
R
commercially-available household
cleaning agents
These may damage the display surface. Do
not put pressure on the display surface
when cleaning. This could lead to
irreparable damage to the display.
X
Before cleaning the display, make sure that
it is switched off and has cooled down.
X
Clean the display surface using a
commercially available microfiber cloth
and TFT/LCD display cleaner.
X
Dry the display surface using a dry
microfiber cloth.
Cleaning the plastic trim
G
WARNING
Care products and cleaning agents containing
solvents cause surfaces in the cockpit to
become porous. As a result, plastic parts may
come loose in the event of air bag
deployment. There is a risk of injury.
324
Care
Maintenance
and
care