Mercedes-Benz CL-Class 2010 Owners Manual - Manual (Page 80)

necessary to adapt the audio format
(
Y page 172).
i By selecting Logic7 ® OFF, all compatible
formats are played back as they are
present on the medium. Due to the design
of the passenger compartment, an
optimum audio experience cannot be
guaranteed for all passengers.
Adjusting 3-D sound
With 3-D sound, you can choose between
Logic7
® ON and Logic7 ® OFF.
X Select Sound Q 3D Sound.
: Current setting
X Selecting a setting: Slide Z V Æ or rotate
c V d .
X Saving setting: Press W.
The setting is saved and the menu is closed.
X Exiting menu without saving changes:
Press back button % or slide X V Y .
i Please note the following:
R
For an ideal sound experience in all
seats, the balance and fader should be
adjusted to the center of the passenger
compartment with Logic
7 ® switched on.
R
The best sound results are achieved by
playing high-quality audio and video
DVDs.
R
For MP3 tracks, the bit rate should be at
least 128 kbit/s.
R 3-D sound does not work for mono-signal
sources, such as on analog AM radio or
in Weather Band.
R
In the event of poor radio reception
quality, e.g. inside a tunnel, you should
switch off Logic
7 ® , as a dynamic switch
from Stereo to Mono could occur,
resulting in temporary sound distortion.
R
With some stereo recordings, the
resulting sound may deviate from
conventional stereo playback.
Switching the audio/video source off/
on
i When you load a CD or DVD, the audio or
video source is activated automatically.
Active audio source
X Switching off: Select Audio Q Audio
OFF.
Playback is paused and the audio source is
switched off;
Audio OFF appears in the
COMAND display.
X Switching on: Select Audio, then the
desired audio source.
or
X Load a CD/DVD ( Y page 165) or an SD
card ( Y page 166).
or
X Connect a USB storage device
(
Y page 72) or media interface device
( Y page 183) to COMAND.
Active video source
X Switching off: Select Video Q Video
OFF.
The audio source is switched off;
Video
OFF appears in the COMAND display.
X Switching on: Select Video, then the
desired video source.
or
X Load a DVD ( Y page 165).
78
COMAND introduction
Control systems
216_AKB; 3; 90, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-15T11:47:50+02:00 - Seite 78