Trip computer menu, Menu, Speed – Mercedes-Benz M-Class 2010 Owners Manual User Manual
Page 140: Controls in detail, Control system
DSR (Downhill Speed Regulation)
programmed default speed
Use this function to program the default
speed the DSR is set to when it is activated.
You can program the default speed between
3 - 10 mph (Canada: 4- 18 km/h). The set
value is increased in 1 mph (Canada:
2 km/h) increments.
X
Press button V or U repeatedly until
the
Vehicle configuration menu appears
in the multifunction display.
X
Press button & or * repeatedly until
the message
DSR Speed appears in the
multifunction display.
The selection marker is on the current
setting.
X
Press button W or X repeatedly until
the desired speed is shown in the
multifunction display.
When DSR is switched on, DSR will use the
programmed default speed to regulate the
vehicle’s speed.
Once DSR is switched on, you can adjust the
set speed using the cruise control lever
(
Trip computer menu
Use the
Trip computer menu to call up
statistical data on your vehicle.
The following information is available:
R
Fuel consumption statistics since start
(
R
Fuel consumption statistics since last reset
(
R
Resetting fuel consumption statistics
(
R
R
When you enter the
Trip computer menu,
you will always see the fuel consumption
statistics since start first.
Fuel consumption statistics since start
X
Press button U or V repeatedly until
the message
From Start appears in the
multifunction display.
:
Distance driven since start
;
Time elapsed since start
=
Average speed since start
?
Average fuel consumption since start
All statistics stored since the last engine start
will be reset approximately 4 hours after the
SmartKey in the starter switch is turned to
position
0 or removed from the starter switch.
Resetting will not occur if you turn the
SmartKey back to position
1 or 2 within this
time period.
Fuel consumption statistics since last
reset
X
Press button U or V repeatedly until
the message
From Start appears in the
multifunction display.
X
Press button & or * repeatedly until
the message
From Reset appears in the
multifunction display.
138
Control system
Controls in detail
164_AKB; 7; 31, en-US
d2ureepe,
Version: 2.11.8.1
2009-09-11T12:07:36+02:00 - Seite 138