Rice Lake 820i Programmable Indicator/Controller - Installation Manual - Manual (Page 60)

56 820i Installation Manual
6.2 Default Print Formats
Table 6-2 shows the default print formats for the 820i and lists the conditions under which each print format is
used. The HDRFMT1 and HDRFMT2 formats are used to specify header information that can be used by the
other ticket formats. The contents of the HDRFMT
x
format can be inserted into any other ticket format using the
<H1> and <H2> formatting commands.
Table 6-2. Default Print Formats
Format Default Format String Used When
GFMT GROSS<G><NL2><TD><NL> Normal mode, no tare in system
NFMT GROSS<G><NL>TARE<SP><T><NL>NET<SP2><N>
<NL2><TD><NL> Normal mode, tare in system
ACCFMT ACCUM<A><NL><DA><TI><NL> Accumulator enabled and displayed, or
setpoint print operation with PSHACCM=ON
SPFMT <SCV><SP><SPM><NL> Setpoint print operation with PSHPRNT=ON
TRWIN <NL>ID<SP><TID><NL2>GROSS<TR1>
<NL2><DA><SP><TI><NL> Press the Weigh In softkey, enter truck ID
number, and press enter.
TRWOUT <NL6>ID<SP><TID><NL2>GROSS<TR1><NL>TARE<SP>
<TR2><NL>NET<SP2><TR3><NL2><DA><SP><TI><NL> Press the Weigh Out softkey, enter truck ID
number, and press enter.
TRFMT REG ID: <TID>: <TR2> SCALE<S> <TD><NL> Truck register currently displayed
ALERT <COMP><NL><COAR1><NL><COAR2><NL>
<CONM1><NL><COPH1><NL>
<CONM2><NL><COPH2><NL>
<COML><NL><ERR><NL> Alert message is sent to specified port when
error indication is generated by an attached
iQUBE . See the iQUBE Installation Manual,
PN 77224, for more information.
HDRFMT1
HDRFMT2 COMPANY NAME<NL>STREET ADDRESS<NL>
CITY, ST ZIP<NL2> Must be inserted into other print format
AUXFMTxx GROSS<G><NL2><TD><NL> Formats AUX1FMT—AUX20FMT
AUDITFMT Fixed format; cannot be edited Press PRINT when audit trail is displayed, or in
response to a DUMPAUDIT serial command.
Note In OIML and CANADA modes, the letters PT (preset tare) are automatically inserted after the printed tare weight.
Alert Format Commands
<COMP> Company name (up to 30 characters) All
<COAR1>
<COAR2> Contact company address, lines 1–3 (up to 30 characters)
<CONM1>
<CONM2> Contact names (up to 20 characters)
<COPH1>
<COPH2> Contact phone numbers (up to 20 characters)
<COML> Contact e-mail address (up to 30 characters)
<ERR> Alert error message (system-generated) ALERT
See the iQUBE Installation Manual, PN 77224, for more information about using alerts.
Command Description Supported Ticket Formats
Table 6-1. Print Format Commands (Continued)