SINGER 4166 - Manual (Page 13)

-11-
BOBBIN WINDING
WINDING THE BOBBIN
spool of thread on the pin.
1.Pivot spool pin into highest horizontal spool pin position.
2.Pass a spool of thread on the spool pin. Secure to place a
3.Pass thread fread from spool through thread guides as shown.
4.Pull end of thread through hole in bobbin as shown.
5.Make sure the bobbin winder shaft is in left position. Place bobbin onto shaft with end
6.Start machine. The thread that is held will snap or may be trimmed with a scissors.
4 5
3 2
1
2
1
REMOVING THE BOBBIN
1.Remove the slide cover by sliding the
locker to right and push down the left
corner of slide cover.
At the same time.
2.Remove the bobbin from the machine.
2.Pass a spool of thread on the spool pin. Secure to place a
Secure it with the spool cap to ensure smooth flow of thread.
of thread coming from top of bobbin. Push bobbin winder shaft to right until it
clicks. Hold onto end of thread.
Bobbin will cease turning when completely filled. Push shaft to left to remove
bobbin.