SINGER 5554 Heavy Duty Combo - Manual (Page 98)

22. Starting and Ending Seams
To Start a Seam
To start a seam on most fabrics, first bring the
thread tail under the presser foot and then to
the left of the machine.
Hold the thread tail and step on the foot controller
to begin sewing.
Sew until you have created a 3" (7.5 cm) chain.
Place the fabric on the feed dogs in front of the
foot. Start sewing.
For heavy or thick fabrics, it is recommended
to use SINGER needles #2022 size 100/16.
Heavy or thick fabrics may be more
difficult to feed than others. In these cases,
start by cutting a notch at the beginning of
the seam about 1" (2.5 cm) down from the
top of the fabric, and along the seam line.
Lift the presser foot and raise the
needles. Place the notch so that the top
edge of the fabric is in front of the needles,
with the cut edge lined up next to the blade.
Lower the presser foot and sew.
Note:
To End a Seam
To end a seam, continue sewing past the end
of the fabric until the thread chain forms.
Cut the thread, leaving at least 3" (7.5 cm) at
the end of the fabric.
*
*
*
*