SINGER CSP1 PRO6S Compact Steam Press - Manual (Page 23)

MODEL CSP1
TROUBLESHOOTING
Problem Cause Remedy
1. Press cannot be
opened using Pressing
Handle. Locking Knob is in locked
position. Turn Locking Knob to open
position.
2. Pressing Plate
cannot be rotated. Orientation Change Button in
locked position. Press the Orientation Change
Button, rotate the pressing Plate.
3. Ironing Board cannot
be rotated. Orientation Change Lever in
locked position. Press the Orientation Change
Lever, rotate the Ironing Board.
4. Press becomes
warm but does not
remove wrinkles. Temperature setting is not hot
enough for fabric. Gradually increase temperature
until desired results are
obtained.
5. Press does not get
warm. Temperature has not been
selected.
Press is not plugged into outlet.
Automatic Shutoff. Pressing Plate
has been lowered against Ironing
Board for 30 seconds or more
without being raised.
Automatic Shutoff. Unit has not
been used for 15 minutes or
more
Turn Temperature Control Dial
to appropriate setting.
Connect Press to outlet.
Push ON/OFF Switch to OFF
(O) position and back to ON (1)
to turn Compact Press back on.
Keep Pressing Plate raised
during warm-up period.
Push ON/OF Switch to OFF (O)
position and back to ON (1) to
turn Compact Press back on. If
necessary, allow Press to warm-
up to selected temperature.
6. No steam. Water level is too low.
Controls have not been set
properly.
Fill water tank.
Turn Temperature Control Dial
to steam zone.
Turn Steam Control in clockwise
direction.
7. Water Drips from
Pressing Plate. Temperature control Dial has not
been set properly.
Pressing Plate has not reached
steam temperature setting.
Turn Temperature Control dial to
steam zone.
Wait for Ready Light.
8. Pressing Handle will
not move into
Automatic Pressure
Position. Item on pressing plate is too thick Use lighter pressure on thick
items.
23