Sewing on buttons – SINGER 3323S TALENT Instruction Manual User Manual
Sewing on Buttons
Install the darning plate. (1)
Change the all purpose foot to the button sewing foot. (2)
Set the stitch length to "0".
Set the machine for zig-zag stitch, then set the width to
number "3" - "6". Turn the handwheel to check that the
needle goes cleanly into the left and right holes of the button.
Adjust the stitch width, as needed, according to the distance
between the holes of the button. Slowly sew on the button
with about 10 stitches.
Raise the needle out of the fabric. Set the machine for straight
If a shank is required, place a darning needle on top of the
button and sew. For buttons with 4 holes, sew through the
front two holes first, push the work forward and then sew
through the back two holes.
Place the button and fabric under the Button Sewing foot, as
illustrated in (3).
stitch again, then sew a few securing stitches to finish.