Smart Power Systems HR-110 - Manual (Page 32)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 31 of 53
Displayed Oil
Temperature in degrees
Fahrenheit
Example of oil temperature display
Figure 19
b. When the Command & Control Center is in Normal mode, pressing the Mode
switch twice will cause the amount of time since the oil filter was last changed
to be displayed (reference Figure 20):
Time Since last Oil Filter
Change in Hours.
Example of oil filter run time display
Figure 20
c. When the Command & Control Center is in Normal mode, pressing the Mode
switch three times will cause the configuration of the generator system controller
to be displayed. The “
” indicates the controller is configured to run an
enclosed generator, and the number displayed corresponds to the maximum
power output of the generator in kilowatts (reference Figure 21).