Universal Remote Control (URS) MX-600 - Manual (Page 18)

17
5. Programming the MX-600 to Control Your Components
4. The remote will be flashing “SELECT BUTTON”.
Press the device you wish to program. (For example, to
program TV, press the TV button.)
5. The remote will be flashing “FROM TABLE”. Select the
device from which the scanned code will be selected.
(Important: If you have already relabeled your device
keys, your LCD screen will not look like the illustration
above. Select the appropriate LCD button for the “FROM
TABLE” using the labels as shown in the illustration on
page 11 of this manual. For example, if you have relabeled
AUX as LIGHTS, you would still push the bottom-left
button to access the AUX Code Table.
6. Point the remote control toward the component and
alternately press the UP (or DOWN ) button on the LCD
and the Power Off button. If the right code number is sent,
the component will turn off right after the code number is
transmitted.
(Please press the UP (or DOWN ) button within 20 seconds
of beginning programming, otherwise the remote will
revert to the SETUP menu, and then after a period of time,
it will go back to the MAIN device page.)