Universal Remote Control (URS) MX-600 - Manual (Page 29)

28
B. Programming Macro Functions To The Ten Device
Buttons
1. Go to the SETUP mode by pressing the MAIN and
ENTER buttons simultaneously for three seconds.
2. Press the MACRO button next to the LCD screen.
3. Important: Press the PAGE button.
4. Press one of the ten device buttons you wish to store
your macro on.
5. Press the functional buttons you wish to store in the
device macro button you selected in the order you want
them stored. You can store up to 20 commands.
Important: Do not press the MAIN button at the beginning
of your macro, or it will not work. You can use the MAIN
button at any other step in your macro.
6. Be sure to end your macro on the Device page that you
would like it to remain on when the macro is sent in normal
use.
7. Save the commands you selected to the macro button by
pressing the CH UP button.
8. Return to Step #4 until you have programmed all of the
Macros that you require.
9. Once you complete the programming and wish to exit
from this mode, press the MAIN button. Exit from the SET
UP mode by pressing the MAIN button once again.
7. Programming Macro Buttons