Universal Remote Control (URS) MX-600 - Manual (Page 27)

26
7 Programming Macro Buttons
A “macro” is a series of commands that you choose to be
sent out with the push of one button.
There are two types of macro functions you can program
with the MX-600:
The M1, M2, M3, POWER ON and POWER OFF
buttons are designed to send out up to twenty commands
from each of the five hard buttons. The ten device buttons
can each send a macro of up to 20 commands when the
device button is pressed for more than 1 second while on
the MAIN page of the remote control.
Important: If you program the POWER ON and POWER
OFF buttons with a macro, they will no longer function as
ON and OFF buttons for your components. Just erase any
macros you have programmed on to these buttons if you
want to restore the original ON and OFF function.
See the “Tips” at the end of this section for help on
programming macros.
A. Programming Macro Functions To M1, M2, M3,
POWER ON And POWER OFF Buttons
1. Go to the SETUP mode by pressing the MAIN and
ENTER button simultaneously for three seconds.
2. Press the MACRO button next to the LCD screen.