Universal Remote Control (URS) MX-600 - Manual (Page 23)

22
2. Programming The Ten Device Buttons
This will program ONE learned code onto the Device
button, so that when you select that Device, it will send out
the learned signal as it changes to that Device's function
pages.
1. Go to the SETUP mode by pressing both the MAIN and
ENT buttons simultaneously for three seconds.
2. Press the LEARN button next to the LCD screen.
3. Important: Press the PAGE button.
4. Place your original remote control head to head with the
MX-600 about 2 inches apart on a flat surface.
5. Select any of the ten device buttons you wish to
program on the MX-600. Press the button on your original
remote control you wish to program into the Device button
you have chosen on the MX-600. Once the MX-600 has
received the signal, the MX-600 will flash “Good” on the
LCD screen, indicating it learned the code correctly. If it
flashes “Fail”, repeat from Step 4 until it learns
successfully. (Please enter the code signal within 20
seconds of programming.)
6. Return to Step #5 until you have programmed all of the
Device buttons that you require.
5. Programming the MX-600 to Control Your Components