Vintage Cellars Extreme ti Series - Manual (Page 16)

EXti 033114
Page 14 | 1-800-343-9463
PREPARING THE UNIT FOR INSTALLATION
Applying Insulation Tape
Locate the (4) precut pieces of black foam tape included with the unit, two larger pieces
and two smaller pieces. To apply, simply peel back the white-paper adhesive covering
and place on the mounting bracket. The large pieces are applied to the top and bottom
while the smaller pieces are for the sides. This foam creates a tight seal between the
bracket and the wall.
Single Piece Mounting Bracket
This sturdy bracket is used to frame the installation location and secures the unit to the
wall studs. The bracket has been designed to hold the unit at a 2º degree angle, this
helps project the air into the space and aids in condensation drainage.
Mounting Bracket Installation
Select your desired bracket mounting location (see diagram below), this location determines the depth
of the installation. For example, position #1 keeps most of the unit out of the cellar while position #4 makes the
back of the unit near flush on the exterior wall. Slide bracket onto unit, pay special attention to the TOP label on the
bracket and the flanges for mounting to the unit are towards the back. Use the (4) supplied 1/2” self tapping screws
to fasten the bracket to the unit. It is imperative to not use self tapping screws longer than 1/2” in length.
If you are installing through an exterior wall, please review the next
page for specific instructions on exterior grill installation.
7.5-9.5” inches In Cellar # 1
# 2
# 3
# 4
11.5-13.5” inches In Cellar
15.5-17.5” inches In Cellar
19.5-21.5” inches In Cellar
5” inch thick wall
(wall thickness may vary) Mounting Bracket
Wine Cellar Exhaust Area