Vintage Cellars Extreme ti Series - Manual (Page 18)

EXti 033114
Page 16 | 1-800-343-9463
THROUGH-THE-WALL INSTALLATION
Installing the Unit
Slide the unit from the outside wall into your wine cellar with the outer flange flush to the wall. Secure the flange
to the wall through the pre-drilled holes. The screws should penetrate the studs as well as the upper and lower
supports to provide adequate support for the WhisperKOOL unit (see illustration). Seal all cracks and gaps around the
WhisperKOOL Extreme unit with an air-tight sealant or caulking to prevent air leakage.
Note: If you use decorative moulding, it should be attached to the walls and never to the cooling unit itself.
The moulding itself should be removable incase the unit needs servicing
Wall Stud
2x4 Upper Support
Mounting Flange
Drain Port
Rear Power
2x4 Lower Support
Back of Unit