Vintage Cellars FGD-0400 - Manual (Page 95)

now in Touch-Tone
™
command mode. Commands are available
to perform the following functions:
• Enable and disable zones, power monitoring, and sound
monitoring
• Recite/Set High and Low alarm limits
• Recite/Set telephone numbers
• Record/Play custom voice messages
• Recite/Set the relay output
• Activate the microphone for listen-in
• Recite status report
NOTE: If a security code is enabled, the 400
will prompt you with “Enter security code.”
Enter the four-digit keypad security code plus
“ #” to enter touch-tone command mode. If
entered correctly, the 400 will respond with
“OK” and you can proceed to enter the com-
mands. If entered incorrectly, the unit will give
you one more chance. If it is incorrect a second
time, the unit will say “Error, goodbye” and
hang up.
The commands are put together based on the letters of a touch-
tone telephone. See typical telephone keypad layout below.
� �
���
�
���
�
���
�
���
�
���
�
����
�
���
�
����
�
Chapter 6: Acknowledgment, Status Report & Remote Access
92