Vinten Radamec Free-d User Manual
Page 44
Vinten Broadcast Ltd
free
-
d
™
Installation Manual V1.4.4
Page 44 of 46
LED indications
d1-green
Off = no power, on= CPU O.K, flashing= CPU resetting (fault)
d3-green
On = video input present and locked
d4-green
On = serial data input present
d5-yellow
On = data freeze mode
d6-yellow
On = too few targets
d7-yellow
On = RMS error high
d8-yellow
On = DSP alert
d9-red
On = fault (code shown on alphanumeric display)
d10-red
On = Xilinx booting error or failed
d11-red
On = DSP booting error or failed
ND1 Alphanumeric Display Error Codes
E1
A processor reset has occurred (this code is only transitory).
E2
Serial communications error.
E3
Vertical blanking failure. This maybe a hardware fault or a problem with the digital
Input.
E4
Xilinx failure. The programmable logic devices have not initialised correctly.
E5
I2C bus failure. Communication between the CPU and peripheral. Hardware fault.
E6
Eprom failure, U3.
E7
DSP has failed to acknowledge a command. If persistent this indicates a hardware.
E8
DSP has failed to accept data. If persistent this indicates a hardware fault.
E9
DSP has failed to provide data. If persistent this indicates a hardware fault.
E10
DSP is flagging an exception error. If persistent this indicates a h/w or s/w fault.
E91
I2C communication failure. No reply
E93
I2C communication failure. Bus error
E94
I2C communication failure. ACK error
E95
I2C communication failure. Undefined state
E96
I2C communication failure. Overflow
F000
The Xilinx FPGAs have not configured correctly. Suspect a hardware fault or
incorrectly programmed U33
F1xx
DSP fault: F100: Failed to boot, F110: memory self test failed or no video i/p present
F118
Software error
F2xx
Video bus VO failed
F3xx
Video bus V4 failed
F4xx
Filter bus RAF1 failed
F5xx
Filter bus RAF2 failed
F6xx
Filter bus RAF3 failed
F7xx
Filter bus SYM1 failed
F8xx
Filter bus SYM2 failed
F9xx
An attempt to select page 2 of video RAM resulted in error code xx (hex)
Faxx
Even video RAM failed.
FBxx
Odd video RAM failed.
FCxx
Dual-port RAM (U10) failed.
FDxx
Dual-port RAM (U4) failed.
FExx
Dual-port RAM (U10) failed.
FFxx
Dual-port RAM (U4) failed.
A transitory error code that does not re-appear on a subsequent reset should not be
considered to indicate a fault condition.