Vinten Radamec Fusion FBH-175 - Manual (Page 16)

15
Switching on
Once all power connections have been made the height drive can be switched on using the power switch (5).
Connect and set the height-extension cable
To connect the height-extension cable (2), proceed as follows:
1. Ensure that the Height Drive is fitted to the pedestal according to the instructions in the relevant Height
Drive Mounting Kit (please refer to Parts List on page 21).
2. Ensure the Height Drive is turned off (5).
3. Ensure that the pedestal is at full height extension and the USB system configuration cable (15) and
ethernet cables (7), (8) are all disconnected.
4. Switch on the Height Drive (5) and wait 20-seconds for the unit to boot up.
5. Pull firmly on the end of the height-extension cable (2) while pressing the jog button (4) to feed out the
cable (2) to full length, toward the fitted upper mounting bracket (1).
6. Depress the pedestal moving column sufficiently to fit the end of the cable (2) into the upper mounting
bracket (1) according to the instructions included with the mounting kit. Allow the column to fully ex-
tend.
7. Set the cable length adjuster (3) to achieve the dimension specified in the mounting kit instructions.
8. Switch off the Height Drive (5) and wait 4-seconds, to allow all power to leave the system.
9. Set the pedestal limits of travel (refer to Learn height stroke length on page 16).
Disconnecting the height-extension cable
If required, to disconnect the height-extension cable (2), proceed as follows:
1. Ensure the column is at full height extension, and the Height Drive is turned off (5).
WARNING! 1. Switching on the height drive (5) will also supply power to the Fusion
head connected to the head power output socket (11).
2. The auxiliary power output socket (12) is not affected by the power
switch (5) and remains permanently live if power is supplied to the power
input socket (10).
3. Keep clear of the column when switching off (5) the height drive. The col-
umn may slowly extend to full height when power is turned off. This behav-
iour is normal.
WARNING! Take care when handling the height-extension cable (2) to avoid trapping/
pinching fingers. The height-extension cable (2) is sprung loaded, and will
automatically retract into the unit.
Note: The jog button (4) will not function if ethernet cables are connected to the EPL ports (7),
(8). Ensure that ethernet cables are disconnected before using the jog button (4).