Vinten Radamec Fusion FBH-175 - Manual (Page 20)

19
Servo Configuration
The servo configuration port (17) is located beneath a protective cover, and allows trained service engineers
to configure servo motor settings. For more information refer to the Fusion FBH-175 Height Drive Technical
Manual (Publication Part No. V4031-4990).
Bottom limit reset
If the height-extension cable adjuster (3) hits the bottom limit stop, the unit will need resetting as follows:
1. Switch off the Height Drive (5) and wait 4-seconds, to allow all power to leave the system.
2. Check the height-extension cable adjuster (3) is set to achieve the dimension specified in the mount-
ing kit instructions.
3. Switch on the Height Drive (5) and wait 20-seconds for the unit to boot up.