Introduction, Pedestal height control, Fusion head provision – Vinten Radamec Fusion FBH-175 User Manual
Page 14
13
(1)
Upper mounting bracket (part of mounting kit)
(2)
Height-extension cable
(3)
Height-extension cable adjuster
(4)
Jog button
(5)
Power switch
(6)
System fuse
(7)
EPL out (ethernet) port
(8)
EPL in (ethernet) port
(9)
Power connector retaining clip
(10)
Power input connector
(11)
Head power output socket
(12)
Auxiliary power output socket
(13)
Cable clamp
(14)
Drive identification setting switch/cover
(15)
System configuration port (USB)/cover
(16)
Emergency stop button
(17)
Servo configuration port/cover
(18)
Lower mounting bracket (part of mounting kit)
Introduction
The Fusion FBH-175 height drive (Fig 1) has been designed to intergrate with the Vinten Radamec Control
System and Fusion heads, remotely driving manual pedestal height position with on-shot quality. A pedestal
mounting kit is supplied to attach the height drive to supported pedestals. For a list of these kits and supported
pedestals, please refer to Parts List on page 21.
Pedestal height control
The main height drive unit mounts to the bottom, non-moving, stage of the column. Pedestal height is controlled
using a cable attached to the top stage of the overgassed pedestal. The height drive feeds the cable in or out
as controlled by the Vinten Radamec Control System.
Fusion head provision
The FBH-175 height drive supplies the connected Fusion head with power (11) and communication to the VRC
Control System (7).