Vinten Radamec SE-500 Elevation Unit - Manual (Page 21)

20
Introduction
This chapter focuses on the mechanical aspects of unpacking and assembling the servo elevation unit and
mounting a pan and tilt head.
Tools you will need
You will need the following tools to assemble the servo elevation unit and mount the pan and tilt head
1. A set of hex wrenches (metric and US sizes)
WARNING!:TO PREVENT PERSONAL INJURY, AND FOR PROPER PERFORM-
ANCE OF THE EQUIPMENT IT IS ESSENTIAL THAT THE PROCEDURES IN THIS
MANUAL ARE FOLLOWED EXACTLY.
Fig 2.1 Assembling the elevation unit
(3)
(6)
(3.1)
(6.1)
(6.2)
(6.3)