Vinten Radamec SE-500 Elevation Unit - Manual (Page 22)

21
Unpacking and assembling
If not already done, unpack and assemble the servo elevation unit as follows (Fig 2.1):
1. Open the box containing the servo elevation unit. Remove and set aside any accessory items and
packing material. Locate the base assembly, the telescopic column and the control box
2. Secure the telescopic column (3) to the base with four M10 screws (3.1). Ensure the telescopic
column is oriented with the connector nearest the control box position.
3. Remove four M3 screws (6.1) securing the control box cover (6.2). Secure the control box (6) to
the base with four M4 screws (6.3). Ensure the control box is oriented with the STOP button to the
right. Refit the control box cover and secure with four M3 screws.
4. Set the assembled servo elevation unit upright and apply the wheel brakes.
Fig 2.2 Installing the pan and tilt head
(1)
(2.1)
(3.2)
(2.3)
(2.2)
(3.4) (3.3)
(2)
(3.5)
(3.6)