Vinten Radamec SE-500 Elevation Unit - Manual (Page 27)

26
Introduction
This chapter covers operation of the servo elevation unit and is limited to the switches, controls and other
features on the unit itself. Operating procedures for controlling the servo elevation unit and pan and tilt head
remotely are described in the User Manual for the specific controller in the installation.
Positioning the unit
Position the servo elevation unit as required and apply all three wheel brakes.
1. To apply the brake, push down on the lever (5.2) situated above the wheel
2. To release, press down on the centre ‘pop-up’ lever (5.1), which is raised when the brake is on.
Fig 3.1 Wheel brakes
(5.1)
(5.2)