Vinten Radamec SE-500 Elevation Unit - Manual (Page 24)

23
1. Connect the ELEVATION connector on the control box to the connector at the top of the
telescopic column using cable AM056-9001.
2. Tighten the cable clamp
Fig 2.3 A typical SE-500 installation
Connect From Cable Type Connect To
Control system/power supply SP-CAB-xx(M) PWR/DATA IN on control box
PWR/DATA OUT on control
box SP-CAB-8 PWR/DATA on pan and tilt head
ELEVATION on control box AM056-9001 Connector on telescopic column
NOTE: In the figure and table above, ‘xx’ denotes the cable length in feet, ‘xx(M)’ the length in metres.