Changing temperature type and measurement units – Welch Allyn 300 Series Vital Signs Monitor - User Manual User Manual
Page 29
Directions for Use
Chapter 2 Setup
25
Changing Temperature Type and Measurement Units
Default setting: F (Fahrenheit predictive).
To change the temperature type and the temperature measurement units:
1.
With the monitor on, press
repeatedly until TEMP MODE appears in the display
window. One or two green LEDs to the right of the temperature window illuminate to
indicate the selected temperature type.
2.
Press
or
as needed to cycle to the desired display:
F (Fahrenheit Predictive)
F M (Fahrenheit Monitored)
C (Celsius Predictive)
C M (Celsius Monitored)
3.
To select the displayed units and return to normal operation, either do nothing for 10
seconds or press any button other than
or
. If you press a function button (such
as
), the monitor returns to normal operation with that function (
) activated.
For information on temperature measurements, see
SYS
DIA
SpO
2
%
/min
mmHg
ºC
ºC
M
TEMP MODE
SYS
DIA
SpO
2
%
/min
mmHg
ºF
ºF
0
98
.
6
20:30:16
79
119