Welch Allyn 901061 Propaq LT Vital Signs Monitor - User Manual - Manual (Page 111)

Directions for Use Monitor configuration 107
ECG aVF Wave Size 1 mV/cm 8 mV/cm, 4 mV/cm, 2 mV/cm, 1 mV/cm,
0.5 mV/cm, 0.2 mV/cm Monitor
SpO
2
Wave Size 2x 1x, 2x, 4x, 8x Monitor
Resp Wave Size 2x 0.5x, 1x, 2x, 4x, 8x, 16x Monitor
ParamSet Enable Yes Yes, No Configuration Utility
NIBP Turbo Mode Enable Yes Yes, No Configuration Utility
Tab Trend Display Interval 5 min 1 min, 5 min, 10 min, 15 min, 30 min,
60 min Monitor, Configuration
Utility
Current screen Display 1 Display 1, Display 2, Display 3 Monitor
Sensitivity (Masimo) Enabled Enabled, Disabled Configuration Utility
Sensitivity (Masimo) Normal Normal, Maximum, APOD Monitor, Configuration
Utility
FastSAT (Masimo) Enabled Enabled, Disabled Configuration Utility
FastSAT (Masimo) Off Off, On Monitor, Configuration
Utility
Averaging Time (Masimo) Enabled Enabled, Disabled Configuration Utility
Averaging Time (Masimo) 8 2, 4, 8, 10, 12, 14, 16 (seconds) Monitor, Configuration
Utility
Display 1
Format Large numerics Large Numerics, Single Waveform,
Dual Waveform, Tabular Trends,
Tabular Trends with Waveform Monitor, Configuration
Utility
Top Waveform (if any) Lead II Lead I, Lead II, Lead III, Lead V, aVR, aVL,
aVF, SpO
2
, Resp
Monitor, Configuration
Utility
Show Top Waveform 6
Seconds No Yes, No Monitor, Configuration
Utility
Show Bottom Waveform 6
Seconds No Yes, No Monitor
Bottom Waveform (if any) Lead V Lead I, Lead II, Lead III, Lead V, aVR, aVL,
aVF, SpO
2
, Resp
Monitor, Configuration
Utility
Tabular Trends Display
Interval 5 min 1 min, 5 min, 10 min, 15 min, 30 min,
60 min Monitor, Configuration
Utility
Table 10. Parameter configuration matrix (continued)
Parameter Factory setting Possible values Where set