Welch Allyn Solarc Light Source - User Manual User Manual
Page 16
14
Chapter 3 Maintenance
Welch Allyn Light Source
2. Remove the five screws from the Solarc Light Source using a
#2 philips head screwdriver. Pivot the cover to expose the
lamp.
Figure 2. Moving the Top Cover
3. Flip up the retaining latch. Pull the lamp base back and up
against the retaining spring to remove the lamp.
4. Remove the lamp, with harness attached and then disconnect
the lamp connector.
Figure 3. Inside the Light Source
5. Replace with Welch Allyn replacement lamp 09500-U only.
DO NOT touch the lamp or the interior reflective surface of
the lamp. Skin oils on the lamp will cause premature lamp
failure. Only hold the outside of the reflector or the base of
the lamp. Remove any grease or fingerprints with a clean
Removable Screws (two on opposite side)
Pivot
32
Retaining Latch
Retaining Spring
Lamp Base
Lamp Connector