Welch Allyn VSM300 Upgrade, 810-2183-01C - Installation Guide - Manual (Page 5)

1
1
Overview
This guide is written for people with a working knowledge of personal computers.
Individuals installing this upgrade must be familiar with the Windows 2000 or XP
operating system and with selecting communication ports on computers, locating files,
and copying files to folders.
This upgrade is intended for use outside the Welch Allyn factory and service-center
environment. It is intended for use with all 300 Series Vital Signs Monitors containing any
combination of the following component software versions:
For monitors containing any combination of the above-listed software versions, this utility
also enables the monitor to accept a SureTemp version 1.2 temperature board. To update
the SureTemp board on monitors containing any software version not listed above,
contact Welch Allyn Technical Support.
This utility includes the following upgrades, which are for the Vital Signs Monitor 300
Series only:
• NIBP module software version 3.20.00
• Main board software version 1.10.00
Component SW Version
Monitor Boot 1.00.00 1.10.00
Monitor Main 1.00.00 1.01.00 1.10.00
NIBP Module 3.00.01 3.00.10 3.10.00 3.20.00
SpO2 Module (Nellcor) 1.8.1.0 1.9.0.1
Temperature Module 1.1 1.2
Note 1. This upgrade procedure might return monitor user settings to the factory
defaults. Refer to Vital Signs Monitor 300 Series Directions for Use
(810-1632-XX) for information about factory default values.
2. Monitors with serial numbers JA020000 and greater were shipped with the
new software installed.
3. This utility is not required when replacing SureTemp boards with the same
version number. Monitors with serial numbers JA020320 and greater were
shipped with SureTemp version 1.2.