Welch Allyn VSM300 Upgrade, 810-2183-01C - Installation Guide - Manual (Page 7)

2
3
Upgrade Procedure
Procedure Summary
It takes approximately 20 minutes to complete the software upgrade and less than a
minute to update the monitor to accept a new temperature board. The upgrade procedure
includes these steps:
1. Read this entire document before installing the update software.
2. Install the Upgrade Tool on each of the computers you will use to upgrade monitors.
3. Use the supplied serial cable to connect an upgrade computer to a monitor.
4. Start the Upgrade Tool.
5. Enter your customer information, responding to prompts to install the upgrade.
6. After upgrading all monitors, print one upgrade record for each monitor, to keep for
your records.
Install the Upgrade Tool on the PC
1. Disconnect any devices connected to the computer serial or USB port you will use.
2. Exit all other running Windows programs.
3. If you have used this computer to install previous versions of Welch Allyn software
upgrades, remove the previous upgrade tools before you begin this upgrade. (See
“Uninstall the Upgrade Tool from the Computer” on page 12.)
4. Insert the Software Upgrade CD-ROM in the CD-ROM disk drive.
If this installation wizard does not appear on the computer screen, go to Step 5 .