Connect the monitor to the computer, Step 5 – Welch Allyn VSM300 Upgrade, 810-2183-01C - Installation Guide User Manual
Page 8
4
Chapter 2 Upgrade Procedure
Welch Allyn Vital Signs Monitor 300
If you see this installation wizard on your screen, click Next, respond to the prompts
displayed in the installation wizard, and click Finish.
5.
If the installation wizard program did not begin, open the Windows Start menu and
click Run.
In the Open field, type D:\Setup.exe (where D: is the CD-ROM drive) and click OK.
Click Next, respond to the prompts displayed, and click Finish.
6.
To repeat the installation process for another computer, repeat from
Connect the Monitor to the Computer
1.
If the computer has only USB ports, install the USB-to-DB9 adapter manufacturer’s
driver software on the computer and proceed to
.
If the computer has a serial port, proceed to
or
2.
Plug the small connector on the serial cable (008-0842-00) into the RS-232 port on the
rear of the monitor.
3.
If the computer has an available serial port, connect the large DB9 adapter on the
serial cable to the serial port.
Serial cable
RJ45 connector
and RS-232 port
DB9 adapter and COM serial port
Monitor power
adapter cable
Computer power cable