Dell Inspiron 5000e - Manual (Page 46)

ClHINT: Ifyou install
additional memory, you must
delete the original hibernate
file before recreating a new
one.
You must recreate the hibernate file if you perform any of the following
actions:
• Delete the hibernate file.
• Install a new hard drive.
• Reformat your hard drive.
• Install additional memory.
Boot (Restart) Your Computer With the System Software CD
1 Save and close any open files, exit any open application programs, and
shut down the computer.
2 If the computer is connected to a port replicator, undock it (see
p a g e 58).
3 Turn on the computer.
4 Press <F2> when you see the Dell logo to access the system setup
program.
5 Press the right-arrow key to highlight Boot.
6 Press the down-arrow key to highlight a device, and then press <F5> or
<F6> to move the device up or down the list until they are in the
following sequence:
— Floppy
— CD ROM/DVD
— Internal Hard Drive
7 Insert the System Software CD into the CD or DVD drive.
8 Press <F10> to save your changes and exit the system setup program.
9 When the Setup Confirmation window appears, press <Enter> to
confirm the configuration changes and exit the system setup program.
10 After the computer restarts and loads the diagnostic utility, press the
down-arrow key to select Exit to MS-DOS and then press <Enter>.
Delete the Old Hibernate File
1 Boot your computer from the System Software CD as described the
preceding section.
4 ^ I S o l v i n g P r o b l e m s