Dell PowerEdge 2600 - Manual (Page 5)

This conversion guide provides instructions for trained service technicians in removing one
or more systems from a rack cabinet and converting the system to a tower version. One rack-
to-tower conversion kit is required for each system to be converted from rack version system
to a tower version system.
A
i\ CAUTION: The system may weigh up to 43 kilograms (95 pounds) when fully
loaded. To prevent personal injury, do not attempt to move the system by
yourself.
Safety Instructions
Use the following safety guidelines to ensure your own personal safety and to help protect
your system from potential damage.
Throughout this safety section, the caution icon j^\) is used to indicate cautions and
precautions that you need to review and follow. For complete safety information, refer to
the
System Information document that came with your system.
Precautions for Rack-Mountable Products
Observe the following precautions for rack stability and safety. Also refer to the rack
installation documentation accompanying the system and the rack for specific caution
statements and procedures.
Systems are considered to be components in a rack. Thus, "component" refers to any system
as well as to various peripherals or supporting hardware.
/K CAUTION: Installing systems in a rack without the front and side stabilizers
installed could cause the rack to tip over, potentially resulting in bodily injury
under certain circumstances. Therefore, always install the stabilizers before
installing components in the rack.
After installing system/components in a rack, never pull more than one
component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may
result in serious injury.
^ NOTE: Your system is safety-certified as a free-standing unit and as a component for
use in a Deii rack cabinet using the customer rack kit. The instaiiation of your system
and rack kit in any other rack cabinet has not been approved by any safety agencies. It
is your responsibiiity to have the finai combination of system and rack kit in a rack
cabinet evaiuated for suitabiiity by a certified safety agency. Deii disciaims aii
iiabiiity and warranties in connection with such combinations.
R a c k - t o - T o w e r C o n v e r s i o n G u i d e |
1-1