Cisco 10720 - Manual (Page 9)

9
Installing the Cable-Management System
78-13101-02
Installing the Cable-Management System
• Power cables and power supplies have been checked for compatibility with your power service.
• Labels on the equipment have been checked to ensure that the power service at your site is suitable
for the Cisco 10720 Internet Router.
• AC- or DC-power source voltage receptacles are easy to reach.
Installing the Cable-Management System
Perform the following steps to install the cable-management system:
Step 1 Power down your router. (Refer to Chapter 5, “Maintaining the Cisco 10720 Internet Router”, in the
Cisco 10720 Internet Router Installation and Configuration Guide.)
Step 2 Attach an ESD-preventive wrist strap to your wrist and to the router; or to a bare metal surface. (See
“Preventing Electrostatic Discharge” section on page 4 .)
Step 3 Attach the cable-management tray to the router using four of the 3.5 mm x 6 mm screws that are shipped
with the router. Secure the cable-management tray by two screws on each side of the router chassis. (See
Figure 4 .)
Figure 4 Attaching Cable-Management Tray
Step 4 Connect all interface cables to their respective ports if necessary.
Step 5 Separate the interface cables and lead them out the sides of the cable-management tray. Use cable ties
to keep the cables together. (See
Figure 5 .)
Note To avoid damage to the cables, avoid excessive bending.
AC OK
DC OK
OTF
AC OK
DC OK
OTF
INPUT 100-2 00- 50/60Hz 2 -5A
DON NOT R EMOVE OR INSERT C ABLES WITH THE P OWER ON
CA RD F AIL
CARD FAIL
LINK/ACTIVE (G)
100 MBPS
PO W ER
RESET
CONSOLE AUX
OV ER TE M P
AC TIV E
CA RD F AIL
SY STE M S TAU S
PO W ER
CA RR IE R
RX P KT W RA P
PA SS T HR U
66296