Canon BJ-10sx - Manual (Page 108)

Appendix C
Printer Mode Command
Summaries and Character Sets
BJ-10e Command Summary
This appendix lists the control codes and ESCape sequences you can use
in BJ-10e mode and Epson LQ mode, and shows the character sets
available in each mode. For a complete description of these
programming commands, you can order the Canon Bubble Jet Printer
BJ-10sx Programmer's Manual. Call the Canon help desk at 1-800-423-
2366 to order this manual
Control codes and ESCape sequences tell the printer how to print a job.
You send commands to the printer in one of two ways:
z You can use your application software to automatically embed
certain commands (such as bold, underline, or indent) within a
document. When the document prints, the embedded command
control the way the printer produces the printed page. Refer to
your application software manual for instructions on sending
commands.
z You can send specific commands directly to the printer, using
either a BASIC programming statement or a printer command
option in your software.
You can use the control codes and ESCape sequences listed in the
following table when the printer is in BJ-10e mode; that is, when DIP
switch 11 is set to OFF. In this mode, the printer can emulate either the
IBM Proprinter X24E (DIP switch 10 OFF) or the Canon Bubble Jet
Printer BJ-130e (DIP switch 10 ON). Differences between IBM
Proprinter X24E emulation and Bubble Jet Printer BJ-130e emulation
are described following the command summary tables.