Canon BJ-10sx - Manual (Page 92)

Removing the Battery Pack
If an AC outlet is not available, you can use the remaining
battery power for limited printing. Press
ON LINE to continue
printing. Each time you press ON LINE , the printer will print
several lines until the battery pack is fully discharged.
Low battery error
When the battery pack becomes fully discharge, a low battery
error occurs. The
POWER light starts to blink, the ON LINE
light goes out, and the ERROR light goes on. In this case, you
must recharge the battery. If you are in the process of printing,
the only way to continue is to connect the AC adapter.
Recharge the battery as described in the previous section,
Charging a Battery Pack.
CAUTION: Recharge the battery pack only when it is fully
discharged. Charging the battery before it is fully discharged
reduces the battery capacity.
NOTE: Make sure you have completed your current print job as
removing the battery pack erases all data in the printer's memory.
Follow these steps to remove the battery pack:
1. Make sure the battery switch is turned off.
2. Lift the printer and rotate the printer stand.
3. Hold the printer securely, and remove the battery
compartment cover.