Mk-377exp saw troubleshooting – MK Diamond MK-377EXP User Manual
Page 28
Advertising
28
MK-377EXP SAW TROUBLESHOOTING
BLADE STOPS TURNING
(A)
Check the ON/OFF Switch is in
the ON position
(B)
Verify all plugs are fully
connected
(C)
Check to see if the Ground Fault
Circuit Interrupter (GFCI) tripped
(D)
Verify the circuit breaker is at least
20 amps - if not, move to 20-amp
circuit
(B)
Verify circuit breaker not
tripped; if it is tripped, reset it
once only
(C)
Check power source voltage
is 120v - if not 120v, move to
another circuit
Advertising