NextoDI NVS2825 - Manual (Page 18)

29
USING AN EXTERNAL HARD DRIVE USING AN EXTERNAL HARD DRIVE
30
The NVS2825 allows a user to copy a memory card to both the NVS2825 hard
drive and to an external USB hard drive at the same time, making two copies of
data in a single operation. The NVS2825 provides “Multi-copy” and “Sync”
functions to make backup more reliable.
13.1. Connecting an external USB hard drive
USB 3.0 Host
(Standard-A)
Adapter
Cancel Cancel
USB Detected
Checking...
512.0 GB
13. Using An External Hard Drive
USB Cable
Reference
● When using Multi Copy & Sync functions, the capacity of the external USB hard
drive should be larger than 128GB. If an external USB hard drive--less than
128GB--is connected, the Copy Menu will be displayed when inserting a
memory card.
● Connect both the NVS2825 and the USB external hard drive to their AC power
adapters. If the NVS2825 is used to copy to another NEXTO backup device
(via the USB adapter cable) the NVS2825 will not need to be connected to the
AC power adapter. (Other Nexto backup devices include the NextoDI ND2700/
ND2730)
13.2. Force Enable External USB HDD
Sometimes the NVS2825 cannot detect the external USB2.0/3.0 HDD automatically.
If this occurs, use the “Force Enable USB”menu.
512.0 GB
Preview
HDD Management
Sync
Setup
Force Enable USB
Wi-Fi Mode
Select Select Back Back
Press the control key once at the
“XCopy Ready”mode to activate the menu.
Press the control key and select
“Force Enable USB”.
If the connected external USB2.0/3.0 HDD is
detected successfully, then a “Success”
message will appear on the LCD display.
Enable USB
Success
512.0 GB
Connect an external USB hard drive using the supplied USB 3.0 micro-B cable
during “XCopy ready” mode. Connect the larger plug to the USB 3.0 port of the
NVS2825. The NVS2825 will detect the device and check the external hard drive.