NextoDI NVS2825 - Manual (Page 9)

7.1. Internal battery
The battery can be charged using the AC power adapter unit delivered with this
product.
● Turn off the NVS2825
● Connect the charger’s wall plug to the NVS’s "DC IN" slot
● Plug the AC power adapter unit into a wall socket
● The LED above the control key shows red when charging
● When the battery is charged, the red LED turns off
● If there is an error when charging, the LED blinks. If this happens,
unplug the AC adapter unit and plug it in again.
Users can also charge the NVS2825 via the car charger or the USB3.0/IEEE 1394b
(FireWire 800) cables.
With a completely empty rechargeable battery, the charging procedure lasts
approximately 4 hours using the AC power adapter, the car charger, or the IEEE
1394b (FireWire 800) cable. With the USB 3.0 cable, charging takes about 9 hours.
11
CHARGING THE RECHARGEABLE BATTERY NVS2825 INTERFACE
12
8. NVS2825 Interface 7. Charging the Rechargeable Battery
Reference
● You must turn off the NVS2825 in order to charge the unit.
● The NVS2825 can be charged via USB without using the AC power adapter
included in the box. A high powered USB connection is needed, i.e. a USB
connection with its own power supply, such as the USB port of a computer or
a USB hub with a power unit.
● If the NVS2825 is operated with a notebook, you must always use the AC
power adapter unit to charge the NVS2825. Notebooks may not deliver the
necessary amount of current via USB.
● The NVS2825 will operate for about two hours with a fully charged internal
battery.
● When connected to a computer using IEEE 1394b (FireWire 800) or USB, the
NVS2825 draws power from the computer, not the internal battery.
● If the NVS2825’s battery is completely discharged, the performance of the
battery may be degraded. It is recommended that the NVS2825’s battery be
recharged before the battery gauge reaches the empty level.
7.2. Rechargeable External battery
The external battery can be charged using the AC power adapter and the car
charger cable.
Reference
● Even if the NVS2825 is fully charged and has been powered off, the
rechargeable external battery will continue to consume power when
connected to the NVS2825.
● Please power off the rechargeable external battery when it is not in use.
● The car charger is used only for charging the internal battery or the
rechargeable external battery.
Reference
● The NVS2825 can be reset via the power key by pressing for more than
7 seconds.
Please note: When the internal HDD is active, a reset may cause damage to
the internal HDD.
Menu Menu Off Off
XCopy Ready
698.6 GB
698.6 GB
Power Off
Ver 1.00
NEXTO VIDEO STORAGE AIR
8.1. Turning the NVS2825 on/off
Press the power key on the right side of the
device for a few seconds in order to turn the
NVS2825 on. The power up logo and firmware
version will be shown on the LCD.
When you see the logo on the LCD screen,
release the button. Otherwise, the NVS2825
will automatically power down.
After checking the system, the NVS2825 goes
into [XCopy ready] mode. You can copy a
memory card in this mode.
The NVS2825 will automatically turn off when
not in use. The user can choose the amount of
idle time (e.g. 15/30/40/50/60/90 seconds)
prior to an automatic power off. When the
Off control option appears on the LCD, the
NVS2825 can be powered off by pressing down
on the control key or power key for more than
1 second.
For details on Setting Auto Power Off,
see chapter 16.