NextoDI NVS2501 - Manual (Page 20)

33
MAKING TWO COPIES IN SINGLE BACKUP(MULTI-COPY) MAKING A SECONDARY COPY(SYNC)
34
When Multi-Copy is in progress,
do not remove the memory card or disconnect
the USB external hard drive.
Multi-Copy completed.
Remove the memory card to return to the
initial display. If you do not remove the
memory card within 50 seconds, the NVS2501
will automatically turn off in order to preserve
battery life. See chapter 10 for the location
and name of the backup folders.
The NVS2501 displays the previous backup
status during the next power on.
Multi Copying
14/16 964.3 MB
98.7 GB
Cancel 1m47s
SxS
Copy Done
Remove SxS
16/16 3.6 GB
95.0 GB
Off 80.7 MB/s
Copy Success
91.4 GB
Preview
Previous
MCopy Success
20090618.003
16 Files
3.6 GB
Ok
(1) Selecting “SYNC” from the menu
USB HDD Info
Total: 149.0Gb
149.0 GB
Select
Used: 37.9 Mb
Sync MCopy
Cancel
(2) Connecting the USB hard drive during “XCopy ready” mode
If a proper external hard drive is
connected, the NVS2501 will display the
status of that drive. Press the control key
button to the left to highlight “Sync” and
briefly press the key to select “Sync”.
149.0 GB
Preview
Select Back
HDD Management
Sector Recovery
Buzzer
Off
Sync
Language
Firmware Update
Index AutoGen. Off
148.0 GB
Cancel
External Device
Insert an
Sync
15. Making A Secondary Copy (Sync)
Move to “SYNC” on the main menu and
select it.
Connect the USB external hard drive to the
[eSATA/USB-Host] combo port of the
NVS2501 as shown in chapter 13.
The “Sync” function synchronizes data between the [NVSPRO] folder of the
NVS2501 and the [NEXTO] folder of an external USB hard drive connected on the
“eSATA/USB Host” connector via USB cable. This function compares the folders
stored in the [NVSPRO] folder of the NVS2501 and the [NEXTO] folder of an
external hard drive. A new folder will be copied to the external hard drive only
if a folder is in the [NVSPRO] folder of the NVS2501—but not in [NEXTO] folder of
an external hard drive.