Petsafe Pawz Away® Indoor Pet Barrier - Manual (Page 10)

10 Customer Care Center 1-800-732-2677
4. Adjust the tightness of the Receiver Collar
to fit your pet’s neck. Check the tightness of
the Receiver Collar by inserting one finger
between the end of a Contact Point and your
pet’s neck. The fit should be snug but not
constricting (4B).
5. Allow your pet to wear the Receiver Collar
for several minutes then recheck the fit.
Check the fit again as your pet becomes
more comfortable with the Receiver Collar.
6. Once you are satisfied with the fit of the
Receiver Collar then you may trim any excess
collar strap as follows (4C):
a. Mark the desired length of the Receiver
Collar with a pen. Allow for growth if your
pet is young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet
and cut off the excess.
c. Before placing the Receiver Collar back onto
your pet, seal the edge of the cut collar by
applying a flame along the frayed edge.
4B
4C
To Re-Thread the Collar
Slide Buckle
Ridges
The slide buckle prevents the collar from
becoming loose around your pet’s neck.
The ridges must be facing up; the collar will slip if
it is not properly threaded.