Programming the mode settings – Petsafe Pawz Away® Indoor Pet Barrier User Manual
Page 13
12
Customer Care Center 1-800-732-2677
www.petsafe.net 13
Programming the Mode Settings
All programming is done through the Barrier Transmitter and the programming is
synchronized with the Receiver Collar. The Receiver Collar cannot be programmed separately
from the Barrier Transmitter.
You may synchronize multiple Receiver Collars to a single Barrier Transmitter at one time.
However, make sure any Receiver Collar you do not wish to synchronize is turned OFF during
the programming procedure. Any collar that is within 5 feet of the Barrier Transmitter and
turned ON may be reprogrammed. Familiarize yourself with the steps outlined below before
attempting to program the Barrier Transmitter and Receiver Collar.
To prevent an unintended correction, do not perform set up procedures while the
Receiver Collar is on your pet.
1. Gather the Receiver Collar(s) you wish to synchronize with the Barrier Transmitter. Turn the
Receiver Collar(s) ON and place less than one foot from the Barrier Transmitter.
2. Turn the Barrier Transmitter OFF by pressing the DOWN (-) arrow button until there are no
bars displayed in the LCD window. Remove the battery door.
3. The mode switch is located inside the
transmitter and is preset to mode A. Move
the switch to the center position for mode
B or to the right position for mode AB
(5A). Once you have selected the desired
mode, replace the battery door.
Note: If you have selected mode AB
you do not need to proceed with
programming the receiver in the next
steps. Receiver Collars set to mode
A or mode B will each receive the radio
signal from a Barrier Transmitter set to
mode AB.
Inside
Battery
Door
Transmitter
Inside View
5A
4. To program the Receiver Collar to either mode A or mode B, press and hold the DOWN
(-) arrow button and then press the UP (+) arrow button for approximately 5 seconds.
Programming is complete when you hear a series of three beeps from the Receiver Collar.
5. Once the Receiver Collar has been programmed, press the UP (+) arrow button to turn the
Barrier Transmitter ON. Check to make sure the black bar(s) appear on the LCD screen indicat-
ing the mode you have selected (5B) and reset the Barrier Transmitter to the desired range.
Mode A
Mode B
Mode AB
5B