Ryobi TSS102L - Manual (Page 17)

17 − English
ASSEMBLY
 Tighten blade bolt securely.
 Replace the lower blade guard and blade bolt cover.
 Securely tighten the blade bolt cover screw.
 Raise and lower the saw head and ensure that the lower
blade guard operates properly.
WARNING:
Make sure the spindle lock button is not engaged before
reconnecting saw into power source. Never engage
spindle lock button when blade is rotating.
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
ALIGNING THE LASER GUIDE LINE
See Figure 17.
Lock the switch by installing a padlock (not included) through
the hole in the switch trigger and closing the shackle.
Draw a line on the workpiece. When the laser guide switch
is turned on it will generate a red line on the work surface.
This line will let you see your mark and the laser guide line
at the same time, and will assist you in lining up the mark
for more accurate cutting of the workpiece.
Align the laser line and the mark with the blade at the
uppermost position. Once both lines are in alignment, do
not move the workpiece.
Remove the padlock then plug the saw into the power
source. Make several practice cuts on different styles and
thickness of material. Repeat the steps above as necessary.
Removing Your Mark:
Position the laser line near the left edge of your mark on the
work surface in order to remove the mark.
To Cut Your Mark:
Position the laser line near or over your mark on the work
surface in order to cut the mark.
To Leave Your Mark:
Position the laser line near the right edge of your mark on
the work surface in order to leave the mark.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
Fig. 17
RED
LINE
LASER
GUIDE
SWITCH
LASER RADIATION AVOID DIRECT EYE EXPOSURE
CLASS IIIa LASER PRODUCT
MAXIMUM OUTPUT: <5mW WAVELENGTH: 635-660nm
• To reduce the risk of injury, user must read and understand the
operator’s manual before using the miter saw.
• Wear eye protection.
• Keep hands out of path of saw blade.
• Do not operate saw without guards in place.
• Do not perform any operation freehand.
• Never reach around the saw blade.
• Turn off tool and wait for saw blade to stop before raising saw
arm, moving workpiece, or changing settings.
• Disconnect the saw from the power source before changing blade
or servicing.
Complies with 21 CFR
Parts 1040.10 & 1040.11 RYLD
Fixer gâchette avant
làser est réglagé. EVITER
L’EXPOSITION: Rayonnement laser émise de cet orifice.
Asegure gatillo antes de ajuste
de laser. EVITE LA EXPOSICIÔN:
Radiación laser se emite por esta abertura.
Lock trigger prior to adjusting
laser. AVOID EXPOSURE:
Laser radiation is emitted from this aperture.