Y-cam Classic Range - Manual (Page 32)

Page 32
6.212 Adhoc Wireless Setup Options
If you want to make a direct wireless connection from your camera to your computer, you will need to setup the Y‐cam
in “Adhoc” mode.
In order to view the Y‐cam directly from your computer you first need to configure the wireless device in your computer
according to the Y‐cam settings above.
Once “Adhoc” has been selected, select a “Security Mode” and type in a connection key, click “Apply”.
You will then need to setup your computer. To do this, follow the instructions below :
1. On your computer click on “Start” then “Control Panel”.
2. Double click the “Network Connections” icon then double click on your “Wireless” network connection icon.
3. Click “View Wireless Networks” and select “ycam” from the list. (If you do not see an the Y‐cam connection,
make sure the camera is powered on and has the above settings then click “Refresh network list” on your
computer. By default the camera broadcasts an SSID of “ycam”)
4. Click “Connect”. Type in the key you set above and press “OK”. You are now connected to the Y‐cam via a direct
(Adhoc) connection.