OFNA Racing Titan Twin - Manual (Page 10)

ASSEMBLY OF THE REAR UPPER ARMS
ASSEMBLY OF THE REAR WHEEL HUB
MP-01B
Rear Upper
Arm
* Leave 12.5mm.
Assembly of the left and right hand side
are the same.
Assembly of the right and lefthand side
are the same.
Assembly of the right and lefthand side
are the same.
*Note: This direction to front.
MP-03
Font/Rear
CVD Shaft
G-25
7mm Ball
G-26
5x35mm
Tunebuckle
G-09
7mm
Plastic
Ball End
#306F
11mm
Ball & Screw
#306C
Rear Hub
( Ball Type )
#306D
Plastic Washer
# 306E
12mm
Alum.
Hex Screw
#267C-O
Wheel Hub
#267E
2.5x16.8mm
Pin
#267D
8x16mm
Ballbearing
#267D
8x16mm
Ballbearing
J-19
4mm
Lower Arm
Shaft
3x25
Hex Screw
M3
Nylon Nut
2.5mm
E-Ring
2.5mm
E-Ring
3mm
E-Ring
3mm
E-Ring
ASSEMBLY OF THE REAR HUB
AND SUSPENSION ARMS
INTO GEAR BOX
5x5mm
Set Screw
*Builds two arms for left and right hand side.
*Builds two hubs for left and right hand side.
*Insert the rear drive shaft
into cap joint before assembly
the rear lower arm.
MP-02
Rear
Lower Arm
*Put the plastic clips
into lower arm shaft.
MP-07
3x64.4mm
Shaft
#306
Plastic Clips