OFNA Racing Titan Twin - Manual (Page 4)

A B
C
CHECKING ENGINE THROTTLE
* Insert into transmitter.
1. Insert AA batteries into
transmitter (8 Pcs).
2.Turn on transmitter.
3.Turn on receiver.
4.Center throttle trims as
shown .
A B C
1. Pull Full Throttle. 1. Push trigger to full
brake position.
2. Adjust alum. Stopper to
increase or decrease
the brake.
Idle Position (A)
Brake (C)
Full Throttle (B)
* Align throttle servo same
as shown.
A
B
C
• Full brake arm position.
Spring compresses
forward and brake rods
pull brake levers.
• Full throttle arm position.
Spring rod pulls throttle
barrel open and brake
rods release pressure on
brake cams.
IMPORTANT
CHECK RADIO THROTTLE
AND STEERING SWITCHES
BEFORE RUNNING CAR
Insert 8 pcs AA batteries into transmitter.
Note:
Battery life is short when using Alkaline batteries. For safety, we
recommend checking Alkaline batteries after 30 minutes. Battery
strength affects radio range; in the case of a monster truck, it affects
brake power. If voltage drops while running the car, you will loose
control and destroy your car! This is NOT covered under warranty.
To increase run time, upgrade receiver batteries to AA Ni-Cad or
NiMH type. But, the most important step you can make, “is to
always use fully charged or fresh batteries when running your car”.
The beat performance is achieved by changing to a 6 volt 5 cell
hump pack, OFNA #10212. The servo have their greatest power at
6 volts.
Radio shown may vary depending on
availability. Therefore radio pictured on
box may or may not be the same.