OFNA Racing Titan Twin - Manual (Page 6)

ASSEMBLY OF THE DIFFERENTIAL
40006
Cap Joint
40006
Cap Joint
30701
4x4mm
Set Screw
40010
2.5x13.8mm
Pin
40010
2.5x13.8mm
Pin
36053
8x16mm
Bearing
36053
8x16mm
Bearing
36053
8x16mm
Bearing
36053
8x16mm
Bearing
( Builds two differentials for front and rear.)
40009
P6
O-Ring
40009
P6
O-Ring
40012
6x15mm
Washer
40012
6x15mm
Washer
40004
Diff.Gear
(Large)
40004
Diff.Gear
(Large)
40003
Diff. Case
40004
Diff. Gear
(Small)
40004
Diff. Gear
(Small)
Option:
49001 - Gears, HD Steel
Note: Diff must always use
gear shim. If no shims are used,
we have found that diff may break.
30779
4 x 10mm
washer
30779
4 x 10mm
washer
30779
4 x 10mm
washer
30773
4mm
Cross pin
30773
4mm
Cross pin
Note:
- Add grease into diff case before closing.
*Put the O-ring
in inside of the diff. case
and press it flush against
the bottom.
40011
Diff. Gasket
3x12mm
Flat Head
Tapping Screw
40214
Large
Bevel Gear
40214
Large
Bevel Gear
ASSEMBLY OF THE GEAR BOX
( Builds two gear box for front and rear.)
40017
Gear Box
40017
Gear Box
49012
13T
Bevel Gear
( l) Smal
40024
13x16x0.2mm
Shim
Note: ALWAYS USE OR ADD MORE!
Adjust gear mesh by using #40024 shims. Add
shim to either side for mesh. Recommend a
tight feel but not binding or loose.
No need to add shims to
this side. Loosening gear
mesh will only cause gear
to skip.