OFNA Racing Titan Twin - Manual (Page 27)

ASSEMBLY OF THE ENGINE
3x20mm
Hex Cap
Screw
3x20mm
Hex Cap
Screw
M3
Nylon Nut
M3
Nylon Nut
A-48
Engine Mount
* Put the nylon nut into
the groove of the engine mount
#264B
7mm
Taper Corn
#174A
3 Pin
Flywheel
#180D
SG
Clutch Nut
#174C
Clutch Nut
#174B
Clutch
Shoes
* Only use this 6.3mm taper cone
for threaded crank shaft with drive
nut.
#174D
Pilot Shaft
#174N
6.3mm
Taper Cone
Threaded Crank
Shaft
* Place the clutch shoes
with the clutch springs
over the 3 pins of the
flywheel.
Using a phillips screw driver
or needle nose pliers and bend
the small end of the clutch
spring behind the pilot shaft
#174D or #180D than press
down. * Fit the flywheel using
a pair of the plier and
cross wrench.
Clutch Gear for Option
M-27C 11T/15T
M-27D 13T/17T
5x9x0.3mm
Washer
#A-47A
5x10x4mm
Ballbearing
#234Y
5x8x2.5mm
Ballbearing
3x8mm
Washer
M-27B
Clutch Gear
(12T/16T)
3x5mm
Cap Screw
M-27A
2-speed
Clutch Bell
#334
Air Filter
A-81
Nylon Straps
* Contacts to the
carburetor.
* Apply filter oil to the
sponge before use.
( Right ) ( Left )
#169
Manifold
#151
Manifold
Adapter
#151
Manifold
Adapter
#139
Manifold
Spring
MW-06
Manifold
(Twin/Right Side)