Vernier EasyData Guidebook - Manual (Page 14)

EasyData Guidebook 13
Collecting Data Automatically (Time Graph)
To collect data in the Time Graph mode
This example uses a force sensor connected to an EasyLink and a TI-84 Plus
calculator. Your screens will vary depending on which sensor and data-collection
device is attached.
1. Turn the calculator on, and start the EasyData app.
After a few seconds, the EasyData main screen is
displayed. The screen shows the current EasyData
mode and the current sensor reading. The default mode
for most sensors is Time Graph.
2. Select and choose New to restore data collection
and sensor defaults.
3. Select to begin collecting data.
4. Data collection will automatically end when all samples
have been collected. To stop data collection early,
select
.
When data collection has ended, EasyData displays a
graph of the collected data.