BendixKing KLN 900 - Abbreviated Guide - Manual (Page 18)

4.2 Direct To - Procedure B
• Select the desired waypoint type (APT, VOR, NDB, INT, or SUP) on the
right page.
• Select the desired waypoint identifier using the following method:
a. Press the right C. The cursor will be over the first character in
the waypoint identifier.
b. Rotate the right inner knob to select the first character of the
desired identifier.
c. Turn the right outer knob one step clockwise to move the cursor to
the second character and then use the right inner knob to select
the second character.
d. Use the right outer and inner knobs as in the previous two steps to
complete the identifier.
• Press D. The Direct To page is displayed on the left side and it con-
tains the desired waypoint identifier.
• Press E to approve the waypoint page displayed on the right side.
The right side will display the NAV 1 page, and the left side will return to
the page which was displayed prior to pressing
D (unless the NAV 1
page was on the left side in which case the pages will revert to the state
they were in prior to the direct to operation). The selected waypoint is
now the active Direct To waypoint.
4.3 Direct To - Procedure C
• Select the desired waypoint type (APT, VOR, NDB, INT, or SUP) on the
right page.
• Select the desired waypoint identifier using the following method:
a. Pull the right inner knob to the “out” position. Make sure the right
cursor function is turned off.
b. Rotate the right inner knob in either direction to scan through the
waypoint identifiers in alphabetical order. The faster you rotate the
knob, the larger the change. Numbers precede letters in the list.
c. When the desired identifier is found, press the right inner knob
back to the “in” position.
• Press D. The Direct To page is displayed on the left side and it con-
tains the desired waypoint identifier.
14